Instruction Manual

Main power switch

The switch on the left side turns the unit on or off. The blue LED above the switch shows that the unit is switched

on.

Technical specifications Pro-Ject Power Box RS Uni 1-way & Uni 4-way

Input voltage: AC 230V/50Hz IEC C15 connector (120V/60Hz US)

Output voltage / current: 1 x 20V / 3A max. (1-way)

4 x 20V / 3A max. (4-way)

Filtration capacity: 1 x 10.000 µF (1-way)

4 x 10.000 µF (4-way)

Output voltage ripple rejection: better than 75dB

Dimensions W x H x D: 201 x 72 x 195mm

Weight: 4,8kg

Service

Should you encounter a problem which you are not able to alleviate or identify despite the above information,

please contact your dealer for further advice. Only if the problem cannot be resolved there, the unit should

be sent to the responsible distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions

for use. Modification or changes to any part of the product by unauthorized persons release the

manufacturer from any liability over and above the lawful rights of the customer.

Pro-Ject Audio Systems is a registered Trademark of

H. Lichtenegger.

This guide was produced by: Pro-Ject Audio Systems

The information was correct at the time of going to

press. The manufacturer reserves the right to make

changes to the technical specification without prior

notice as deemed necessary to uphold the ongoing

process of technical development.