User Manual

Switching on and off

Pressing the ON/OFF switch alternately starts or stops the motor.

Changing replay speed

To play 45 r.p.m., put the drive belt over the larger diameter part of the motor pulley. To revert to 33 r.p.m.

repeat the proceedings using the smaller step on the pulley.

Connection to the amplifier

The record player has two possible outputs – Line OUT with integrated preamplifier and Phono OUT for

connection to the preamplifier. If you choose Phono OUT, than use the Phono input (sometimes labelled

gram, disc or RIAA) on your amplifier. Make sure that the phono input offers correct matching and

amplification for the type of cartridge used. If you choose Line OUT, than use the Line inputs (like CD, Tuner,

Tape or Video).

Take care about connecting the left and right channel correctly. The right channel

is usually marked red, the

left channel black or white. Check the manual of your amplifier for relevant information. An earthing wire

may be connected to the screw terminal between the sockets if you encounter humming problems.

Connecting a headphone

Connect the headphones to the ¼“(6,3mm) jack socket on the front of the Turntable.

Volume control knob

The headphone amplifier is turned off when the volume knob is turned to its end anti-clockwise. To turn the

headphone amplifier on, turn the volume knob clockwise and then adjust the level to the required volume.

Technical specifications MM phono pre-amplifier (Essential III Headphone)

Gain

40dB

Output voltage typically

500mV/1kHz at 5mV/1kHz

Input impedance

47kohms/120pF

Noise floor

88dB (A weighted)

RIAA-equalisation curve accuracy

THD:

Headphone Output Power

20Hz-20kHz / max. 0,5d

<0,05%

61wM (16 Ohm)/32mW (32 Ohm)

Technical specifications MM phono pre-amplifier (Essential III Headphone)

Gain

40dB