INSTRUCTIONS FOR USE Pro-Ject Stereo Box DS
Dear music lover, thank you for purchasing a PRO-JECT AUDIO amplifier. In order to achieve maximum performance and reliability you should study these instructions for use carefully. ! Warning of a hazard for the user, the unit or possible misuse. Important notice. Safety instructions AC outlet voltages vary from country to country. Before connecting to the mains, make sure that the voltage in your area meets the voltage requirements printed on the power supply.
Remote control 1 ON/OFF ON/OFF short press turns the unit on, long press takes it back into standby. Powered on, a short press activates and deactivates mute CH+ 0_ and 0_ and VOL VOL+ VOL- CH- CH 0 adjust the sound volume 0 select the inputs VOL + CH + Front panel controls - + Stereo Box DS To switch on from standby or to standby on the front turns the unit on or back into standby. The display shows STANDBY when the unit is in standby.
Connecting to a Computer Connect the USB-input of the amplifier (unit must be switched on) to a free USB-socket on your computer and turn it on/make sure it is powered on. The amp will be automatically recognised by the computer. There is no need to install a driver manually. Please note: Connection should be made to an USB-socket of your computer directly. Connecting to USB-hubs or switches can cause problems.
Technical specifications Pro-Ject Stereo Box DS Power output: Frequency response: Channel separation: Noise floor: THD: Gain: Line-level inputs: Input sensitivity: Input impedance: USB-input: USB signal: D/A converter: Supported audio format: 2 x 35W/60W at 8 ohms/4 ohms (both channels driven) 20Hz - 20kHz (-0,1dB, +0,2dB) >65dB at 20kHz >100dB (A weighted) 0,1% at 10W 33dB 4 pairs RCA/phono sockets 350mV 100kohms Mini B socket. USB cable supplied Digital serial data protocol USB 1.
