User guide

Replacing batteries

Proceed as follows:

 Unlock and slide open the battery case cover

 Replace the battery.

Make sure the battery is the right way round !

 Close the battery case cover

Battery type: 1 x CR2032 / 3V or 1 x CR2025 / 3V

Do not dispose the batteries as ordinary domestic refuse. Please dispose your exhausted batteries at

the appropriate collection sites - usually located at supermarkets and drugstores.

Technical specifications Pro-Ject Stereo Box S

Power output: 2 x 25W/30W at 8 ohms/4 ohms (both channels driven)

Frequency response: 20Hz - 20kHz (±0,2dB)

Channel separation: >40dB at 20kHz

Noise floor: >-100dB (A weighted)

THD: <0,05% at 10W

Gain: 22dB

Line-level inputs: 2 pairs RCA/phono sockets

Input impedance: 20kohms

Record Out: 3-pole 3,5mm co-axial jack

Speaker connectors: 4mm  banana plugs, spades connectors or naked wire

Outboard power supply: 20V/3A DC (peak 7A DC), suitable for your country's mains supply

Power consumption: 3A DC, <1W in standby

Replacement battery remote control: 1 x CR2032 / 3V

Dimensions W x H x D (D with sockets): 103 x 36 x 104 (122)mm

Weight: 720g without power supply

Technical specifications Pro-Ject Media Box S

Audio formats: MP3, WMA, AAC (no DRM support)

USB-input: High-Speed 2.0, 24/96. Typ A-socket.

Power supply for 2,5” hard drives (5V DC/max. 500mA)

Hard drives: FAT16 and FAT32 (no exFAT or NTFS support)

Card reader: SD card (secure digital), max. 32GB

Line-level output: 1 pair RCA/phono sockets

Output voltage: max. 1Vrms

Noise floor 100dB/1V

Digital output: co-axial (S/PDIF)

D/A-converter: Texas Instruments TLV320AIC23B. 24Bit/96kHz, upsampler

Outboard power supply: 9V/2A DC, suitable for your country's mains supply

Power consumption: 1,8A DC max. – with hard drive connected. <1W in standby

Replacement battery remote control: 1 x CR2032 / 3V or 1 x CR2025 / 3V

Dimensions W x H x D (D with sockets): 103 x 36 x 104 (109)mm

Weight: 550g without power supply

Technical specifications Pro-Ject Speaker Box 5

Recommended amplifier power: 10 - 150 watts

Impedance: 8ohms

Sensitivity (1W/1m): 86dB

Dimensions W x H x D / weight: 160 x 255 x 210mm / 4,2kg