INSTRUCTIONS FOR USE Pro-Ject Xtension 10 Evolution
14 9a 45.0 - Speed Change + 24 23 22 7 22 A B 2 © Audio Trade GmbH · Pro-Ject Xtension 10 Evolution · Revision 2012.8.
Pro-Ject Xtension 10 Evolution Controls, features and connections 1 2 3 4 5 6 7 8/18 9 14 15 16 17 21 22 23 24 Low voltage cable and power supply socket Stepped drive pulley Drive belt * 3a Hook Platter * ON/OFF switch, speed selector Tonearm counterweight * 6a Downforce scale Tonearm lift lever Tonearm rest and removable transport lock Tonearm tube 9a Tonearm base 5-pole DIN output socket Anti-skating weight adjustment scale Anti-skating weight * Anti-skating weight wire support Headshell with finger lift
Set-up The deck is supplied partially disassembled and carefully packaged for safe transport. Carefully remove all parts from the transport packaging. Screw the four feet (22) onto the threaded bolts located on the underside of the plinth. Make sure the surface you wish to use the turntable on is level (use a spirit level) before placing the turntable on it. Carefully place the platter bearing housing over the bearing axle.
Anti-skating force adjustment The anti-skating force must be adjusted corresponding to the downforce as follows: Downforce Groove in the stub (15) 10 - 14mN 1st from bearing rings 15 - 19mN 2nd " " " 20mN and bigger 3rd " " " Hang the loop of the thread of the anti-skating weight in the groove of the anti-skating stub (15) corresponding to the downforce applied to your cartridge and hang the thread in the groove of the wire support (17).
Starting the motor, Stand By Pressing the button Speed Change will switch on the player from stand by. Press and hold the push button Speed Change to put the unit into stand by. Changing replay speed The belt must be on the smaller (50Hz models) larger (60Hz models) diameter part of the motor pulley. Press the button Speed Change to switch between 33 and 45 r.p.m.. The selected speed will be displayed digitally. To replay records at 78 r.p.m. perform the following steps: Remove the pulley cover.
Potential incorrect use and fault conditions Pro-Ject turntables are manufactured to the highest standards and undergo strict quality controls before leaving the factory. Faults that may possibly occur are not necessarily due to material or production faults but can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the following list of common fault symptoms is included. The platter doesn't turn although the unit is switched on: The unit is not connected to the mains power supply.
