INSTRUCTIONS FOR USE Pro-Ject RPM 9.
© Audio Trade GmbH · Pro-Ject RPM 9.1 Acryl · Revision 2012.7.
Pro-Ject RPM 9.
Set-up The deck is supplied partially disassembled and carefully packaged for safe transport. Carefully remove all parts from the transport packaging. Screw the three feet (22) onto the threaded bolts located on the underside of the plinth. Make sure the surface you wish to use the turntable on is level (use the supplied spirit level) before placing the turntable on it. Carefully place the platter bearing housing over the bearing axle.
Adjusting the vertical tracking angle (vta) Put a record and the record weight on the platter. When the needle is lowered into the record groove and the tonearm is not resting on the lift arm, the tube of the tonearm should be parallel to the surface of the record. If it is not loosen both hexagon screws in the tonearm base just enough to allow vertical movement of the arm pillar without force and slide the arm up or down until it is parallel.
Mains power connection The turntable is supplied with a power supply suitable for your country's mains supply. Check the label before connecting to ensure compliance with the mains rating in your house. Connect the low voltage plug from the power supply to the record player's motor unit (13) before connecting the power supply to the mains. Switching on and off Pressing the power switch (20) alternately starts or stops the motor.
Potential incorrect use and fault conditions Pro-Ject turntables are manufactured to the highest standards and undergo strict quality controls before leaving the factory. Faults that may possibly occur are not necessarily due to material or production faults but can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the following list of common fault symptoms is included. The platter doesn't turn although the unit is switched on: The unit is not connected to the mains power supply.
Accessories ! Please remove feet bevore repacking Tonearm transport lock Motor base Motor Record weight Platter Tonearm counterweight Power supply 8 © Audio Trade GmbH · Pro-Ject RPM 9.1 Acryl · Revision 2012.7.
