INSTRUCTIONS FOR USE Pro-Ject RPM 10.
14 14 17 6 16 6a 15 9a 7 9 8 18 21 14 2 © Audio Trade GmbH · Pro-Ject RPM 10.1 Evolution · Revision 2013.2.
Pro-Ject RPM 10.
Set-up The deck is supplied partially disassembled and carefully packaged for safe transport. Carefully remove all parts from the transport packaging. Make sure the surface you wish to use the turntable on is level (use the supplied spirit level) before placing the base (25) on it. Screw the three feet (22) onto the threaded bolts located on the underside of the plinth and place the turntable on the base (25). Carefully place the platter bearing housing over the bearing axle.
Adjusting the vertical tracking angle (vta) Put a record and the record weight on the platter. When the needle is lowered into the record groove and the tonearm is not resting on the lift arm, the tube of the tonearm should be parallel to the surface of the record. If it is not loosen both allen screws in the tonearm base just enough to allow vertical movement of the arm pillar without force and slide the arm up or down until it is parallel.
Connection to the amplifier The record player has gold plated female RCA phono sockets (14) so you can substitute the interconnect cables supplied with higher quality cables such as the Pro-Ject Connect it interconnect cables for connection to the amplifier if you wish. Use the Phono input (sometimes labelled gram, disc or RIAA) on your amplifier. Make sure that the phono input offers correct matching and amplification for the type of cartridge used.
Useful tips The base and the record player should be positioned on a low-resonance surface such as wood or multiple layer ply board to avoid structural vibrations disturbing replay. Potential incorrect use and fault conditions Pro-Ject turntables are manufactured to the highest standards and undergo strict quality controls before leaving the factory.
Accessories ! Please remove feet bevore repacking Tonearm transport lock Motor base Motor Record weight Platter Tonearm counterweight Power supply 8 © Audio Trade GmbH · Pro-Ject RPM 10.1 Evolution · Revision 2013.2.
