INSTRUCTIONS FOR USE Pro-Ject Essential II
12 14 14 10 22 30 4 0 5 4a 9 2 66 3 6 8 5 7 11 1 13 14 Controls, features and connections 1 Power switch 2/22 Stepped drive pulley and drive belt * 3 Platter with felt mat * 4/4a Tonearm counterweight * 5 Tonearm lift lever 6/66 Tonearm rest and removable transport lock 7 Tonearm tube 8 Anti-skating stub with anti-skating weight adjustment scale 9 Anti-skating weight support hoop 10 Anti-skating weight with wire * 11 Headshell with finger lift and fitted Ortofon OM
Pro-Ject Essential II Dear music lover, thank you for purchasing a PRO-JECT AUDIO record player. In order to achieve maximum performance and reliability with this record player you should study these instructions for use carefully. ! Warning of a hazard for the user, the unit or possible misuse. Important notice. ** Your turntable has been delivered with a factory fitted and adjusted cartridge, please ignore the cartridge set up instructions unless changing the cartridge at a later date.
Anti-skating force adjustment Hang the loop of the thread of the anti-skating weight in the groove of the anti-skating stub (8) corresponding to the downforce applied to your cartridge and feed the thread through the loop of the wire support (9).
Fitting and connecting the cartridge ** All cartridges with half inch mounting holes can be fitted. Leaving the needle's protection cover on, fit the cartridge to the headshell (11) using the screws supplied with the cartridge by passing one screw through each slot in the headshell (11). Do not tighten the nuts yet. Connect the tonearm wires to the cartridge pins as follows: white left channel positive (L+) red right channel pos.
Potential incorrect use and fault conditions Pro-Ject turntables are manufactured to the highest standards and undergo strict quality controls before leaving the factory. Faults that may possibly occur are not necessarily due to material or production faults but can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the following list of common fault symptoms is included. The platter doesn't turn although the unit is switched on: The unit is not connected to the mains power supply.
Accessories Lid Tomearm transport look Tonearm counterweight Power supply © Audio Trade GmbH · Pro-Ject Essential I I / Pro 8.6UP / Ortofon OM 5E · Revision 2013.6.
