Instruction Manual

Fitting and connecting the cartridge

** All cartridges with half inch mounting holes can be fitted. Leaving the needle's protection cover on, fit the

cartridge to the headshell using the screws supplied with the cartridge by passing one screw through each

slot in the headshell (21). Do not tighten the nuts yet.

Connect the tonearm wires to the cartridge pins as follows:

white left channel positive (L+)

red right channel pos. (R+)

green right channel return (R -)

blue left channel return (L -)

The full sound quality of the record player can only be achieved if the cartridge is correctly adjusted. Particular

tools like the PRO-JECT alignment tool are required to accomplish this job properly.

If you are not well acquainted with the adjustment of cartridges you are advised to call upon the willing help of

your PRO-JECT dealer to accomplish this task for you.

Please note: The finger lift (21) must be fitted on top of the headshell under the cartridge fixing bolts

or nuts - not between headshell and cartridge body.

Adjusting a cartridge and tonearm calls for the greatest care in order to avoid damaging the cartridge

or tonearm bearings. Leave this work to your dealer if you are in any way unsure of the necessary

steps and precautions to be taken.

Maintenance and cleaning

Your record player requires little or no regular maintenance. Remove dust with a slightly moistened antistatic

cloth. Never use a dry cloth because this will create static electricity which attract more dust! Antistatic

cleaning fluids are available at specialist stores but must be applied sparingly to avoid damage to rubber

parts. It is recommended to fit the needle cover before cleaning or maintenance is carried out to avoid damage.

If the player is not used over a long period of time the drive belt can be removed to prevent unequal stretching.

Always disconnect the record player from the mains power supply as a precaution before maintenance!

Technical specifications PRO-JECT 2 Xperience Classic / Acryl / Pro-Ject 9cc Evolution

Nominal speeds 33/45 r.p.m.

Speed variance ±0,5 %

Wow and flutter ±0,08 %

Signal to noise 70dB

Effective tonearm mass 8g

Effective tonearm length 9 " (230mm)

Overhang 18mm

Power consumption 2W

Outboard power supply 16V/500mA AC, suitable for your country's mains supply

Dimensions (W x H x D) / Acryl 460 x 133 x 360mm, dust cover open 460 x 390 x 460mm

Dimensions (W x H x D) / Classic 460 x 160 x 360mm, dust cover open 460 x 417 x 460mm

Weight 7,6kg

Technical specifications MM-Cartridge Ortofon 2M Red

Frequency range 20-22.000Hz

Channel separation 22dB/1kHz

Output voltage 5,5mV

Recommended load impedance 47kohms/amplifier connection – MM-input

Compliance/stylus type 20μm/mN – elliptical

Recommended tracking force 18mN

Weight 7,2g