INSTRUCTIONS FOR USE Pro-Ject 2 Xperience Acryl Pro-Ject 2 Xperience Classic
5 2 © Audio Trade GmbH · Pro-Ject 2 Xperience Acryl / Classic / Ortofon 2M Red · Revision 2014.4.
Pro-Ject 2 Xperience Acryl / Classic Controls, features and connections 1 2 3 5 6 7 8/18 9 10 11 12 13 14 15 16 17 20 21 22 23 Motor transport locks Stepped drive pulley Drive belt * 3a Hook * Sandwich platter * Tonearm counterweight * 6a Downforce scale Tonearm lift lever Tonearm rest and removable transport lock Tonearm tube 9a Tonearm base Lid * Lid hinges Hinge fasteners Power supply socket Phono output sockets and earth connection Anti-skating stub with anti-skating weight adjustment scale Anti-skatin
Set-up The deck is supplied partially disassembled and carefully packaged for safe transport. Carefully remove all parts from the transport packaging. Screw the three feet (23) onto the threaded bolts located on the underside of the plinth. Make sure the surface you wish to use the turntable on is level (use a spirit level) before placing the turntable on it. Remove the two red transport screws (1) which secure the motor (22) during transportation.
Mains power connection The turntable is supplied with a power supply suitable for your country's mains supply. Check the label before connecting to ensure compliance with the mains rating in your house. Connect the low voltage plug from the power supply to the socket (13) on the rear of the record player before connecting the power supply to the mains.
Fitting and connecting the cartridge ** All cartridges with half inch mounting holes can be fitted. Leaving the needle's protection cover on, fit the cartridge to the headshell using the screws supplied with the cartridge by passing one screw through each slot in the headshell (21). Do not tighten the nuts yet. Connect the tonearm wires to the cartridge pins as follows: white left channel positive (L+) red right channel pos.
Potential incorrect use and fault conditions Pro-Ject turntables are manufactured to the highest standards and undergo strict quality controls before leaving the factory. Faults that may possibly occur are not necessarily due to material or production faults but can sometimes be caused by incorrect use or unfortunate circumstances. Therefore the following list of common fault symptoms is included. The platter doesn't turn although the unit is switched on: The unit is not connected to the mains power supply.
Accessories Tonearm counterweight Lid 2 motor transport screws (marked red) Feet Feet Tonearm transport lock Power supply Platter ! 8 Please remove feet bevore repacking © Audio Trade GmbH · Pro-Ject 2 Xperience Acryl / Classic / Ortofon 2M Red · Revision 2014.4.
