Manual

© Audio Trade GmbH · Pro-Ject Phono Box DS+ · Revision 2013.1.15
3
Front panel controls
+
-
Phono Box DS+
To switch on from standby or to standby
turns the unit on or back into standby (press and hold to switch into standby mode). The display shows
STANDBY when the unit is in standby.
After power on, the current settings are displayed for approx. ten seconds. Pressing
again, will display the
settings again.
Settings, subsonic filter
The four push buttons are used to set:
Input impedance / ohms
Input capacitance / pF
Input gain / dB
Subsonic-Filters - on/off
Input impedance
In capacitance
Input gain
Subsonic filter
:
:
:
:
10
47p
40dB
ON
100
147p
45dB
OFF
1k
267p
60dB
47k
367p
65dB
While the current settings are displayed, calls up the setup menu. and move the curser up and down.
and select a menu item. A long press on stores the settings.
To find out which type your cartridge is please consult the literature accompanying your cartridge. The
literature for cartridges should also specify the correct input impedance (low-output MC cartridges) and the
correct input capacitance (high-output MC and MM cartridges), into which the cartridge is designed to work.
If in doubt please consult your dealer.
The memory retains its contents through a power off/on cycle and a power failure.
Examples of typical settings
Ortofon 2M Red (MM)
Input impedance
Input capacitance
Input gain
:
:
:
47k
147p
40dB
Ortofon X5-MC (high-output MC)
Input impedance
Input capacitance
Input gain
:
:
:
47k
367p
45dB
Ortofon Rondo Red (low-output MC)
Input impedance
Input capacitance
Input gain
:
:
:
10
*
60dB
* Any setting.
Input capacitance is irrelevant
for low-output MC cartridges