Owner manual

Mains power connection

The headphone amplifier is supplied with a power supply suitable for your country's mains supply. Check the

label before connecting to ensure compliance with the mains rating in your house. Connect the low voltage

plug from the power supply to the socket Power ~16V before connecting the power supply to the mains.

Technical specifications Pro-Ject Head Box SE II

Power output: 700mW/30ohms, 110mW/300ohms

Headphone connection: > 30ohms

Signal to noise: 110dB (115dB - A weighted) at full output

Frequency response: 20Hz – 20kHz/-0,03dB

THD (IMD): 0,003%/30ohms, 0,007/300ohms

Gain: 12dB

Headphone jacks: 3-pole ¼“ (6,3mm ∅) phono socket

Line-level output: 1 pair RCA/Phono sockets

Outboard power supply: 16V/1.000mA AC, suitable for your country's mains supply

Power consumption: 16V/230mA AC

Dimensions W x H x D (D with sockets): 103 x 72 x 144 (150)mm

Weight: 1.080g without power supply

Potential incorrect use and fault conditions

No signal on one or both channels:

No connection between headphone and headphone amplifier ore amplifier. This could be due

to a faulty plug, broken wire or solder joint or simply loose plug/socket connection.

Headphone does not work:

Headphone volume control is at minimum.

Amplifier Tape-Monitor circuit is not activated.

Service

Should you encounter a problem which you are not able to alleviate or identify despite the above information,

please contact your dealer for further advice. Only when the problem cannot be resolved there should the

unit be sent to the responsible distributor in your country.

Warranty

The manufacturer accepts no responsibility for damage caused by not adhering to these instructions

for use. Modification or change to any part of the product by unauthorized persons release the

manufacturer from any liability over and above the lawful rights of the customer.

PRO-JECT is a Registered Trademark of H. Lichtenegger.

This guide was produced by: Audio Trade GmbH

The information was correct at the time of going to

press. The manufacturer reserves the right to make

changes to the technical specification without prior

notice as deemed necessary to uphold the ongoing

process of technical development.