User`s manual

11
12
13
12. Identify the Right Handlebar (10), which is
marked with a “Right” sticker, and orient it as
shown.
Have a second person hold the Right
H
andlebar (10) near the right side of the Upright
(5).
Locate the indicated wire tie in the Upright (5).
Tie the lower end of the wire tie to the Pulse
Wire (34) inside the Right Handlebar (10). Next,
pull the upper end of the wire tie upward out of
the top of the Upright. Then, untie and discard
the wire tie.
Tip: Avoid pinching the Pulse Wire (34).
Attach the Right Handlebar (10) to the Upright
(5) with two M8 x 16mm Patch Screws (102).
Attach the Left Handlebar (11) in the same
way.
Tip: To prevent the Pulse Wires (34) from
falling into the Upright (5), secure the Pulse
Wires with the wire ties.
102
34
10
33
11
5
Wire Tie
Slot
Battery Cover
Screw
Batteries
Jack
Batteries
13. The Console (33) can use four D batteries (not
included); alkaline batteries are recommended.
IMPORTANT: If the Console has been
exposed to cold temperatures, allow it to
warm to room temperature before inserting
batteries. Otherwise, you may damage the
console displays or other electronic compo-
nents. Remove the screw, remove the battery
cover and insert the batteries into the battery
compartment. Make sure to orient the batter-
ies as shown by the diagram inside the
battery compartment. Then, reattach the bat-
tery cover.
To purchase an optional power adapter, call
the telephone number on the cover of this
manual. To avoid damaging the console, use
only a manufacturer-supplied power adapter.
Remove the battery cover, remove the batteries,
and plug one end of the power adapter into the
jack inside the battery compartment on the con-
sole; plug the other end into an outlet installed in
accordance with all local codes and ordinances.
Route the wire on the power adapter through
the slot in the battery cover and reattach the
battery cover.
Avoid pinching the
Pulse Wire (34)