Operation Manual

10
3. Pull the Upright Wire (81) and the base ground
wire (A) through the indicated hole in the
Base (94).
If there is a screw (B) pre-installed in the side
of the Base (94), remove and discard it. Attach
the ground wire (A) to the Base with a #8 x 1/2"
Silver Screw (10).
Press the Grommet (77) into the square hole in
the Base (94).
81
3
94
77
Hole
10
A
B
2. Make sure that the power cord is unplugged.
Attach the Left Wheel Cap (111) to the Base (94)
with two #8 x 3/4" Screws (2).
Attach the Right Wheel Cap (not shown) to
the Base (94) in the same way.
2
111
94
2