User`s manual

12. The Console (5) requires four 1.5V “D” batteries

(not included); alkaline batteries are recommend-

d. I

MPORTANT: If the elliptical exerciser has

been exposed to cold temperatures, allow it

o warm to room temperature before insert-

ing batteries into the Console. If you do not

do this, the displays or other electronic com-

ponents may become damaged.

See the inset drawing. Remove the battery cover

from the Console (5) and insert four batteries

into the Console.

Make sure that the batteries

are oriented as shown by the diagram in the

battery compartment.

Then, reattach the bat-

tery cover.

Note: The Console (5) can be operated with an

optional power supply instead of batteries.

purchase a power supply, call the toll-free

telephone number on the front cover of this

manual.

Plug one end of the power supply into

the jack on the console. Plug the other end of

the power supply into an appropriate outlet that

is properly installed in accordance with all local

codes and ordinances.

Have a second person hold the Console (5) near

the Upright (6) as shown. Connect the console

wire to the Wire Harness (48). Insert the excess

wire downward into the Upright.

Attach the Console (5) with four M4 x 16mm

Self-tapping Screws (79).

13. Make sure that all parts of the elliptical exerciser are properly tightened. Note: Some hardware may be

left over after assembly is completed. To protect the floor or carpet from damage, place a mat under the

elliptical exerciser.

Battery Cover

Console

Wire