User Manual

14
16. Remove and discard the wire tie on the Main
Wire (32).
While a second person holds the Console (30)
near the Upright (2), plug the Main Wire (32) and
the Pulse Wire (31) into the matching recep-
tacles on the back of the Console.
The connectors on the Main Wire (32) and
the Pulse Wire (31) should slide easily into
the receptacles and snap into place. If a con-
nector does not slide easily into a receptacle,
turn the connector and try again. If you do not
connect the connectors properly, the console
may become damaged.
Then, insert the excess wire into the Upright (2).
Tip: Avoid pinching the wires. Attach the
Console (30) to the Upright (2) with four
M4 x 16mm Screws (56) start all of the Screws,
and then tighten them.
See step 5. Tighten the M10 x 53mm Screw
(73), the M10 x 20mm Screw (74), and the
M10 x 60mm Bolt (72). Then, press the
Accessory Tray (50) into place.
2
56
31
30
32
16
17. Make sure that all parts are properly tightened before you use the elliptical. Extra parts may be included.
Place a mat beneath the elliptical to protect the floor.
Avoid pinching
the wires
30
92
93
15
15. Attach the Tablet Holder (92) to the back of the
Console (30) with four #8 x 15mm Screws (93);
start all of the Screws, and then tighten them.