User`s manual

DIAGRAM OF THE CONSOLE

ZONE TRAWmt_ _O_ CAL/ FAT CAL TWE/OISTANCE

ulse Sensor --

• *

__---_ Key _Speed Control Note: If there is a thin

sheet of clear plastic

Y'_L_ on the face of the

-- Clip console, remove it.

Pressthree batteriesinto the battery compartment, with

the negative (-) ends of the batteries touching the

springs.Close the battery cover.

Batteries----_ Cover

STEP BY STEP CONSOLE OPERATION

Before operating the console, make sure that the power

cord is properly plugged in. (See HOW TO PLUG IN

THE POWER CORD on page 7.)

The console requires three "AA" batteries (not in-

cluded); alkaline batteries are recommended. Open the

battery cover as shown in the drawing at the upper right.

Next, step onto the foot railsofthe treadmill• Find the

clipattached to the key (see the drawing at the top of

this page), and slidethe clip ontothe waistband of your

clothing.

Followthe steps below and on page 9 to operate the

console.

Insert the key fully into the power switch.

Insertingthe key will not

turn on the displays.

The displays will turn on

when the ON/CLEAR

buttonis pressed or the

walking belt is started.

Note: Ifyou just installed

batteries, the displayswill already be on.