User`s manual

5. Move your right hand to the position shown at the dght,

and holdthe treadmill firmly. Using yourleft hand, liftthe

storage latch. Raise the treadmill untilthe locking pin

snaps into the storage latch. Make sure that the locking

pin Is Inside the storage latch, and that the storage

latch Is fully closed.

See the upper inset drawing. Attach a Base Pad (95) to

the bottom of the Stabilizer Plate (94) in the indicated lo-

cation.

Stand behind the treadmill. Hold the Right Crossbar

Bracket (36) and the Left Crossbar Bracket (not shown).

Place one foot on the base inthe indicated Iocati6n.

Tip the treadmill back slightly.While thetreadmill is held

in this position,a second person should slide the

Stabilizer Plate (94) onto the base (see the lower inset

drawing). Keeping your foot on the base, carefully tip the

treadmill up until it is resting on the base. Make sure that

the Stabilizer Plate (94) stays on the base.

Attach the Stabilizer Plate (94) to the base with a

Stabilizer Plate Bolt (71), two Stabilizer Plate Washers

(66), and the Stabilizer Plate Nut (60) as shown.

Refer to assembly drawing 5 at the top of this page. Hold

the upper end of the treadmill with your right hand as

shown. Using your left hand, liftthe storage latch. Pivot

the treadmill slightlyuntil the locking pin is out of the stor-

age latch.

Hold the treadmill firmly with both hands, and lower the

treadmill to the floor. To decrease the possibility of In-

jury, bend your legs and keep your back straight.

8. Remove the paper backing from the Adhesive Clip (44).

Press the Adhesive Clip ontothe Frame (84) in the indi-

cated location. Press the 3/16" Allen Wrench (57) into the

Adhesive Clip. The use ofthe 3/16" Allen Wrench isde-

scribed on page 13.

Make sure that all parts are tightened before you use the

treadmill. Note:To protect the floor or carpet, place a

mat under the treadmill.

Storage Latch_

6 36 ,,_=_ _'_

Base_

I ,