User`s manual

TROUBLE-SHOOTING

Most treadmill problems can be solved by following the simple steps below. Rnd the symptom that ap-

plies, and follow the steps listed. If further assistance is needed, call our toll*free HELPMNE at 1-800-736.

6879, Monday through Saturday, 7 a.m. until 7 p.m. Central Time (excluding holidays).

1. SYMPTOM: THE POWER DOES NOT TURN ON

a. Make sure thatthe power cord is plugged into a surge protector, and that the surge protectorIs plugged into

a propariygrounded outlet. (See HOW TO PLUG IN THE pOWER CORD on page 7.) Use only a UL-listed

surge protector, rated at 15 ampa, with a 14-gauge cord offive feet or less in length.

b. After the powercord has been plugged in, make sure that the key is fully inserted intothe console. (See step

1 on page 8.)

c. Check the circuitbreaker located on the treadmill near the

power cord. Ifthe switch protrudes as shown, the cimuit

breaker has tripped. To reset the circuitbreaker, wait for five

minutesand then press the switch back in.

Tripped

Reset

2, SYMPTOM: THE POWER TURNS OFF DURING USE

a. Check the cimuit breaker located on the treadmill frame near the power cord (see 1. c. above). If the cimuit

breaker has tripped, wait for five minutes and then press the switch back in.

b. Make sure thatthe power cord is plugged in.

c. Remove the key from the console. Reinsert the key fully into the console. (See step 1 on page 8.)

d. If the treadmillstill will not run, please call our toll-free HELPLINE.

3, SYMPTOM: THE WALKING BELT SLOWS WHEN WALKED ON

a. Use only a UL-listed surge protector, rated at 15 amps, with a 14-gauge cord of five feet or less in length.

h. If the walking belt stillslows when walked on, please call our toll-free HELPLINE.

4. SYMPTOM: THE WALKING BELT IS OFF-CENTER OR SLIPS WHEN WALKED ON

a. If the walking belt has shifted to the left, first remove the key and

UNPLUG THE POWER CORD. Using the 3/16" allen wrench,

turn the left rear roller adjustment bolt clockwise 1/4 of a turn.

Plug in the power cord, insert the key and run the treadmill for a

few minutes. Repeat until the walking belt is centered.

b. If the walking belt has shifted to the right,first remove the key

and UNPLUG THE POWER CORD. Using the 3/16" allen

wrench, turn the left rear roller adjustment bolt counterclockwise

1/4 of a turn. Plug in the power cord, insertthe key and run the

treadmill for e few minutes. Repeat untilthe walking belt is cen-

tered.