User`s manual

ASSEMBLY

CAUTION: Read and follow step I below before removing the restraining tie (see drawing 1). If the restrain.

Ing tie is removed prematurely, serious bodily Injury may result, Assembly requires two people. Set the tread-

millin a cleared area and remove the packing materials except for the restraining tie. Do not dispose of the

packing materials until assembly iscompleted. Use the HARDWARE IDENTIFICATION CHART in the center of

this manual to identify the parts used in assembly. Assembly requires the Included allen wrench L, a

phillips screwdriver ,,====_, and two adjustable wrenches _:;::::::_D.

1. Slide the Left Upright (1) onto the left side of the Base

(59). It may be necessary to firmly push down on the

Left Upright until it Is fully seated on the Base.

Remove the'restraining tie from the Base.

Attach the left handrail to the Base (59) with a Handrail

Bolt(93), 3/8" Washer (67), and Handrail Nut (4). Do not

tighten the Handrail Bolt yet. Using the allen wrench,

tightentwo Upright Screws (63) intothe LeftUpdght (1)

and the Base.

2, -Slide the Right Upright (44) ontothe right side of the

Base (59). It may be necessary to firmly push down

on the Right Upright until it is fully seated on the

Base. Be careful not to pinch the Wire Harness (26)

between the Right Upright and the Base.

Attach the dght handrail to the Base (59) with a Handrail

Bolt (93), 3/8" Washer (67), and Handrail Nut (4). Do not

tighten the Handrail Bolt yet. Using the allen wrench,

tighten two Upright Screws (63) into the Right Updght (44)

and the Base.

Hand tighten.the Handrail Nuts (4) used in steps I and 2.

Using a wrench, tighten the Handrail Bolts (93) used in

steps 1 and 2.

Remove the wire ties (not shown) attaching the Console

Base (9) to the Right Upright (44).

3. Set the Console Base (9) on the Left and Right UPdghts

(1, 44).

While one person carefully feeds any slack Wire Hamess

(25) down into the Right Updght (44), a second person

should carefully pull the slack Wire Harness from the

lower end of the Right Upright.

Attach the Console Base (9) with four Screws (75).

Alignthe holes in the Book Rack (62) with those in the

Console Base (9). Attach the Book Rack to the Console

Base with four Screws (75) as shown.