User`s manual

4, Withthehelpof asecondperson,carefullylowertheLeft

and Right Uprights (1,44) untilthe handraits are resting

on the floor.

5, Attach six Base Pads (57) to the bottom of the Base (59)

in the indicated locations. Note: An extra Base Pad may

be included.

See drawing 4 above. With the help of a second person,

raise the Left and Right Uprights (1,44) until the Base

(59) is resting flat on the floor.

Before moving the treadmill, see HOW TO MOVE THE

TREADMILL on page 11.

Insert two Resistance Bracket Bolts (107) with Bracket

Washers (70) into the Left Upright (1). Slide two Star

Washers (103), a Spacer (106), and two more Star

Washers (103) onto the Bolts. Make sure that the

Spacer is turned so the widest side Is facing the Left

Upright:. Tighten the Bolts intothe Resistance Bracket

(104) at the lower end of the left Upper Body Arm (96).

(Note: It may be necessary to loosen the Resistance

Knob [97] End pivot the Resistance Bracket.)

Attach the right Upper Body Arm (96) as described

above. Make sure that both Upper Body Arms are on the

correct side of the Console Base (9) as shown.

See drawing 2 on page 5. Feed the slack Wire Hamess

(25) into the Base (5.9).

7. Remove the backing from the Adhesive Clip (77). Press

the Adhesive Clip onto the Rear Roller Endcap (78) in the

indicated location. Press theAllen Wrench (76) into the

Adhesive Clip.

_lake sure that all parts are tightened before you use the

treadmill. Note: To protect the floor or carpet, place a

mat under the treadmill. For information on ordering a

mat, see REPLACEMENT PARTS on the back cover.