Operation Manual

29
Before moving the treadmill, insert the key into the
console, raise the incline to the maximum incline
level, remove the key, and unplug the power cord.
Due to the size and weight of the treadmill, mov-
ing it requires two or three persons. Hold the rear
of the treadmill near the rear endcap. Lift the treadmill
upward until it rolls freely on the wheels. CAUTION: To
decrease the possibility of injury or of damage to
the treadmill, do not lift the treadmill by the plastic
endcap. Do not pull on the tray.
Carefully roll the treadmill on the wheels to the
desired location, and then lower it to the level position.
CAUTION: To reduce the risk of injury, use extreme
caution while moving the treadmill. Do not attempt
to move the treadmill over uneven surfaces.
Make sure that the treadmill rests firmly on the floor. If
the treadmill rocks even slightly, turn the Leveling Feet
(100) as needed until the rocking motion is eliminated.
Wheel
Rear
Endcap
Tray
100
HOW TO MOVE THE TREADMILL
HOW TO ADJUST THE CUSHIONING SYSTEM
Remove the key from the console and unplug the
power cord. The treadmill features a cushioning sys-
tem that reduces the impact as you walk or run on the
treadmill. To learn more about the runner’s flex cush-
ion, see page 8.
To i n crea se t h e fi rmne s s o f the wal k ing plat f orm , ste p
off the treadmill and turn the cushion adjustor handle
counterclockwise until the handle is facing the
Upright (116).
To d e crea se t h e fi rmne s s, s tep off the tre a dmil l an d
turn the cushion adjustor handle clockwise until the
handle is facing the back of the treadmill.
Cushion
Adjustor
Handle
116