User`s manual

4. Insert a Handrail Extension (85) into the poston the left

Upright (82). Align the holes in the Handrail Extension

with the holes in the post. If necessary, tap the Handrail

Extension with a rubber mallet to fugyinsert it.Next, attach

the Handrail Extension by tighteningthree Small Screws

(76) into the indicated holes. Note that the hole in the left

side of the post is not used. Note: If there is only one

hole in the top of the post, tighten the third Small

Screw into the hole In the left side of the post.

Identify the Left Foam Grip (110), which has a large

cutout in the right side, Slide the Left Foam Gdp as far as

possible onto the post on the left Updght (82). It may be

helpful to apply soapy water to the Hand_l Extension (85).

5. Make sure that the front edge of the Left Foam Gdp (110)

is under the Console Base (87) as shown. Tighten a

Small Screw (76) into the slde of the Left Foam Gdp as

shown.

Attach the Right Foam Grip (not shown) and the other

Handrail Extension (not shown) as descn'bedin step 4

and this step.

Note: There may be extra screws when assembly is

completed.

Cutout

110

6. Refer to drawing 6a: Locate the left Rear Foot (59) on

the treadmill. If the 'left Rear Foot touches the floor, go to

step 7. If there is aspace between the left Rear Foot and

the floor, follow the:instructions below.

Hold the treadmill firmly with both hands, and raise the

treadmill to the storage position as descdbed on page 20.

Refer to drawing 6b. Using a phillipsscrewdriver,remove

the Screw (60), the right Rear Foot (59), and the Rear

Foot Spacer (11) from the treadmill. Reaftach the right

Rear Foot without the Rear Font Spacer. Hold the tread-

mill with both hands, and lower the treadmill as

descdbed on page 21.

Check the left Rear Foot (59 [see drawing 6a]). If the left

Rear Foot is still off the floor, raise the treadmill and re-

move the left Rear Foot. Snap the Rear Foot Spacer (11)

onto the left Rear Foot and reattach the left Rear Foot

and the Rear Foot Spacer. Carefully lower the treadmill.

7. Make sure that all parts are tightened before you use the treadmill. Keep the Included allen wrench in a

secure place. The allen wrench is used to adjust the walking belt (see page 21). To protect the floor or carpet

from damage, place a mat under the tmedmill.

-7