User`s manual

PROBLEM: The walking belt slows when walked on
SOLUTION: a. Use only a UL-listed surge suppressor, rated at 15 ampe, with a 14-gange cord of five feet or less
in length.
b. If the walking belt is overtightened, treadmill perfor-
mance may decrease and the walking belt may be-
come damaged. Remove the key and UNPLUG THE
POWER CORD. Using the alien wrench, turn beth
rear roller adjustment belts counterclockwise, 1/4 of a
turn. When the walking belt is properly tightened, you
should be able to lift each side of the walking belt 3 to
4 inches off the walking platform. Be careful to keep
the walking belt centered. Plug in the power cord, in-
sert the key and run the treadmill for a few minutes.
Repeat until the walking belt is properly tightened.
b !3 i
Rear Roller Adjustment Bolts
c. if the walking belt still slows when walked on, please call our toll-free HELPLINE.
PROBLEM: The walking belt is off-center
SOLUTION: a. If the walking belt has shifted to the left, first remove
the key and UNPLUG THE POWER CORD. Using the
alien wrench, turn the left rear rolleradjustment bolt
clockwise, and the right bolt counterclockwise, 114of a
turn each. Be careful not to overtightenthe walking bell
Plug in the power cord, insert the key and run the tread-
mill for a few minutes. Repeat untilthe walking belt is
centered.
a
b*
If the walking belt has shifted to the right, first re-
move the key and UNPLUG THE POWER CORD.
Using the allen wrench, turn the left rear roller adjust-
ment bolt countemlockwise, and the right bolt clockwise,
114 of a turn each. Be careful not to overtightea the
walking belt. Plug In the power cord, insert the key and
run the treadmill for a few minutes. Repeat un_ the
walking belt is cantered.
PROBLEM: The walking belt slips when walked on
SOLUTION: a. Ifthe walking belt slips when walked on, first remove
the key and UNPLUG THE POWER CORD. Using the
allen wrench, turn both rear miler adjustment bolts
clockwise, 1/4 of a turn. When the walking belt is cor-
rectly tightened, you should be able to lift each side of
the walking belt 3 to 4 inches off the walking platform.
Be careful to keep the walking belt centered. Plug in the
power cord, insert the key and carefully walk on the
treadmill for a few minutes. Repeat until the walking belt
is preperly tightened.
PROBLEM: The incline of the treadmill does not change con'eclJy or does not change when [FIT.com
CD's and videos are played
SOLUTION: a. With the key Inserted In the console, press one of the INCUNE buttons. While the incline is
changing, remove the key. Alter a few seconds, re-insert the key.The treadmill will automati-
cally rise to the maximum incline level and then return to the minimum level. This will recalibrate
the incline.
_4