User`s guide

BEFORE
YOU BEGIN
ASSEMBLY
9
INTRODUCTION
IMPORTANT
PRECAUTIONS
ELLIPTICAL
OPERATION
CONDITIONING
GUIDELINES
TROUBLESHOOTING
& MAINTENANCE
LIMITED
WARRANTY
ASSEMBLY STEP 3
A) Open HARDWARE BAG FOR STEP 3.
B) Slide the CONSOLE MAST BOOT over the CONSOLE MAST. Carefully pull console wires through the console
mast. Attach the CONSOLE WIRES to the pre-attached routing wire. Discard wire when finished.
C) Attach the CONSOLE MAST to the MAIN FRAME using BOLT (A), SPRING WASHER (D) and WASHER (B) from
the front and 2 BOLTS (E), 2 WASHERS (B) and 2 NUTS (F) from the side.
D) Attach the TOP CAP to the MAIN FRAME by snapping tabs in place.
E) Slide CONSOLE MAST BOOT down CONSOLE MAST onto the TOP CAP.
BOLT (A)
20 mm
Qty: 1
NUT (F)
20 mm
Qty: 2
BOLT (E)
55 mm
Qty: 2
SPRING WASHER (D)
15 mm
Qty: 1
WASHER (B)
17 mm
Qty: 3
HARDWARE BAG FOR STEP 3 CONTENTS :
MAIN FRAME
BOLT (A)
BOLTS (E)
WASHERS (B)
SPRING WASHER (D)
WASHER (B)
CONSOLE MAST
MAIN FRAME
CONSOLE MAST
CONSOLE MAST BOOT
TOP CAP