Operation Manual

1. Make sure that the power cord is unplugged.

Remove and discard the two screws (A) and

the shipping bracket (B) from the right side of

the Base (74). Then, remove and discard the

screws and shipping bracket (not shown)

from the left side of the Base.

• Assembly requires two persons.

• Place all parts in a cleared area and remove the

packing materials. Do not dispose of the packing

materialsuntilyounishallassemblysteps.

• After shipping, there may be an oily substance

on the exterior of the treadmill. This is normal. If

there is an oily substance on the treadmill, wipe

it off with a soft cloth and a mild, non-abrasive

cleaner.

• To identify small parts, see page 6.

• Assembly requires the following tools:

the included hex keys

one Phillips screwdriver

scissors

• To avoid damaging parts, do not use power tools.

ASSEMBLY

2. Locate the Upright Wire (63) bundled around the

front of the Base (74). Cut the plastic tie securing

the Upright Wire. Pull the end of the Upright Wire

out of the indicated hole.

See the inset drawing. Cut the plastic tie near

the Upright Wire (63). Be careful not to dam-

age the Upright Wire.

Hole

Cut

Tie