Operation Manual

11
9
104
111
Console Assembly
116
116
106
10. Identify the Right Handrail (101) which is marked
with a “Right” sticker. Remove the tie from the
Right Handrail. If necessary, press the M8 Cage
Nut (34) back into place.
Hold the Right Handrail (101) near the console
assembly. Route the console wire around the
side of the Right Handrail as shown, and through
the slot in the Right Handrail.
If necessary, adjust the Console Frame (111) to
align the holes in the Right Handrail (101) with
the holes in the Console Frame.
Attach the Right Handrail (101) to the Console
Frame (111) and the console assembly with
two M8 x 25mm Patch Bolts (5), two M8 Star
Washers (10), an M5 x 16mm Bolt (108), and a
1/4" Star Washer (73). Make sure the console
wire is not pinched. Start all three Bolts, and
then tighten all of them.
Attach the Left Handrail (not shown) as
described above. Note: There is not a wire on
the left side.
Tighten the #8 x 1" Screws (107). Be careful not
to overtighten the Screws.
101
108
5
111
Slot
Tie
10
10
73
Console
Wire
Console
Assembly
34
9. Set the console assembly face down on a soft
surface to avoid scratching the console.
Loosen the four #8 x 1" Screws (107). Carefully
pivot the Console Frame (111) to the position
shown. Do not pivot the Console Frame too
far or you will break the ground wire.
Identify the Left and Right Accessory Trays (104,
106). Attach the Accessory Trays to the console
assembly with eight M4 x 13mm Screws (116).
Carefully pivot the Console Frame (111) back
down to the console assembly.
107
107