Operation Manual

1. Make sure that the power cord is unplugged.

Remove and discard the two screws (A) and the

shipping bracket (B) from the right side of the

Base (74).

Then, remove and discard the screws and the

shipping bracket (not shown) from the left

side of the Base (74).

• Assembly requires two persons.

• Place all parts in a cleared area and remove the

packing materials. Do not dispose of the packing

materialsuntilyounishallassemblysteps.

• After shipping, there may be an oily substance on

the exterior of the treadmill. This is normal. If there

is an oily substance on the treadmill, wipe it off

with a soft cloth and a mild, non-abrasive cleaner.

• To identify small parts, see page 6.

• Assembly requires the following tools:

the included hex keys

one Phillips screwdriver

one adjustable wrench

To avoid damaging parts, do not use power tools.

ASSEMBLY

2. Locate the Upright Wire (63) bundled between

the Base (74) and the Belly Pan (52). Route the

Upright Wire into the Base and out of the indi-

cated hole.

Press a Base Cap (70) into each side of the

Base (74).

See the inset drawing. Cut the plastic tie near

the Upright Wire (63). Be careful not to dam-

age the Upright Wire.

Hole

Cut

Tie