Specifications

EM-506 (N-07/03) 5-11
6. Depress the palmbuttons and lower the ram to a
position where there is .06" to .12" (1.5mm to
3.1mm) clearance between the upper and lower dies.
7. Loosen the ram die clamp nuts or unclamp the upper
power clamps to release the upper die. Loosen the
filler block set screws or unclamp the lower power
clamp to release the lower die.
8. Turn the CONTROL ON-OFF keyswitch to the
“OFF” position and remove the key.
IMPORTANT: When loosening the clamps for
upper die, be sure upper die will remain
trapped between the lower die and the slot in
ram nose. See Figure 5-20.
9. The dies can now be removed from the end of the
machine. They may be removed either together or
individually, depending on their size and weight.
Use proper material handling equipment and
methods.
FIGURE 5-20 Removing tooling