User manual

Chapter 4 Setting up Your PS-A Unit
4-5
Installing the HDD Unit
After opening the PS-A unit’s packing box, check that a hard disk unit is installed. If it is not, you will need to
install it.
Setting Up the PS-A Unit’s System Information
If your PS-A unit does not have a pre-installed HDD, you will need to install an HDD unit and then configure
that drive’s system information. Be sure to check that the system successfully recognizes the drive.
Setting Up an HDD with Pre-installed OS
Follow the setup procedures given in the Pre-installed Type HDD Unit Installation Guide.
 PS-A Hard Disk Data
Setting up the PS-A unit’s utilities will create a [Proface] folder on the C drive. The following diagram
describes the configuration of this folder. (For all Windows
®
versions)
SEE
Pre-installed HDD Unit Installation Guide
SEE
Pre-installed HDD Unit Installation Guide
• The actual organization may differ depending on your PS-A unit’s OS.
• Setting up the PS-A unit’s utilities automatically copies the hardware control driver (Psamon.sys,
Blctrl.sys) to the system folder.
[Proface]
[4 in 1] 4 in 1 Driver
[Audio] Audio Driver
[Blsaver] Backlight Control Screen Saver
[Disp] Backlight Control Console Application
[Display] Graphic Accelerator Driver
[Keyclick] Keyboard Emulation Application
[PsaApi] API-DLL
[Setup] CD Image
[Shutdown]
[Client] Remote Shutdown Client
[Sysmon] System Monitor/RAS Application
[USB] USB 1.1 Driver