User manual

Chapter 3 System Setup
3-19
PCI/VGA Palette Snoop
The two selections available are [Disabled] and [Enabled]. The [Disabled] selection is factory set and recom-
mended for most users. However, if a VGA or MPEG board is used, set this to [Enabled]. For setting details,
refer to your VGA or MPEG board’s Installation guide.
3.2.8 IRQ Resources
Selecting IRQ Resources from the PnP/PCI Configuration menu and the following screen will appear.
IRQ-3 (4/5/7/9/10/11/12/14/15) assigned to
This setting determines the type of device assigned to the IRQ. This function is available when the [PnP/ PCI
Configurations] menu’s [Resources Control By] option is set to [Manual].
[PCI Device].. Select to use a PnP-ready PCI card.
The available settings are [PCI Device] and [Legacy ISA].
The initial settings are all [PCI Device].
Phoenix AwardBIOS CMOS Setup Utility
IRQ Resources
IRQ-3 assigned to [PCI/ISA PnP]
IRQ-4 assigned to [PCI/ISA PnP]
IRQ-5 assigned to [PCI/ISA PnP]
IRQ-7 assigned to [PCI/ISA PnP]
IRQ-9 assigned to [PCI/ISA PnP]
IRQ-10 assigned to [PCI/ISA PnP]
IRQ-11 assigned to [PCI/ISA PnP]
IRQ-12 assigned to [PCI/ISA PnP]
IRQ-14 assigned to [PCI/ISA PnP]
IRQ-15 assigned to [PCI/ISA PnP]
Item Help
Menu Level 4
Legacy ISA for devices
comPS-Biant with the
original PC AT bus
specification, PCI/ISA
PnP for devices
comPS-Biant with the
PS-Bug and PS-Bay standard
whether designed for
PCI or ISA bus
architecture
↑↓→←: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults