User manual

Chapter 3 System Setup
3-15
ECP Mode Use DMA
Designates the ECP mode's DMA channel. [1] and [3] are available selections, however, this item can be set
when the Parallel Port Mode is set to [ECP], [ECP+EPP 1.7]or [ECP+EPP 1.9]. The factory default setting is
[3].
EPP Mode Select
When [EPP] or [ECP + EPP] mode is selected, this feature allows you to select the EPP mode protocol. [EPP
1.7] or [EPP 1.9] can be selected. The factory default setting is [EPP 1.9].
Onboard Legacy Audio
Designates if audio features are Sound Blaster Pro compatible.
Available selections are [Disabled] and [Enabled]. The factory setting is [Enabled].
Sound Blaster
Available selections are [Disabled] and [Enabled].
When [Enabled] is selected, the unit is Sound Blaster Pro compatible.
The factory setting is [Disabled].
SB I/O Base Address
Designates the Sound Blaster Pro’s I/O address.
Available selections are [220H], [240H], [260H] and [280H]. The factory setting is [220H].
SB IRQ Select
Designates the Sound Blaster Pro’s IRQ.
Available selections are [IRQ5], [IRQ7], [IRQ9] and [IRQ10]. The factory setting is [IRQ5].
SB DMA Select
Designates the Sound Blaster Pro’s DMA.
Available selections are [DMA0], [DMA1], [DMA2] and [DMA3]. The factory setting is [DMA0].