User manual

Chapter 3 System Setup
3-13
Primary (Secondary) Master (Slave) PIO
Designates the IDE Primary (Secondary) Master (Slave) channel’s PIO data transfer mode.
Available selections are [Auto], [Mode 0], [Mode 1], [Mode 2], [Mode 3] and [Mode 4].
The factory setting is [Auto].
IDE Primary (Secondary) Master (Slave) UDMA
Designates the IDE Primary (Secondary) Master (Slave) channel’s UDMA data transfer mode.
Available selections are [Disabled] and [Auto]. The factory setting is [Auto].
Onboard LAN
Disables/enables the LAN connector. The available settings are [Disabled] and [Enabled]. The factory default
setting is [Enabled].
Onboard CardBus Controller
This setting determines whether to enable the CardBus Controller or not. Settings available are [Disabled] or
[Enabled]. The factory default setting is [Enabled].
Init Display First
When both a PCI and an AGP display boards are installed, this setting designates which will have first prior-
ity. Settings are [PCI slot] or [Onboard/AGP]. The factory default setting is [PCI slot].
IDE HDD Block Mode
This setting determines whether to enable the Block Mode on the HDD supporting the Block Mode.
The available settings are [Disabled] and [Enabled]. The factory default setting is [Enabled] and is recom-
mended for most users.
Onboard FDD Controller
Designates whether the PS-A’s FDD (Floppy Disk Drive) controller is enabled or disabled.
Settings available are [Disabled] or [Enabled]. The [Enabled] selection is factory set.
Onboard Serial Port 1
Designates the PS-A’s Serial Port 1 I/O address and interrupts. The selections include [Disabled], [Auto],
[3F8/IRQ4], [2F8/IRQ3], [3E8/IRQ4] and [2E8/IRQ3]. The [3F8/IRQ4] selection is factory set and recom-
mended for most users.