User manual

Chapter 3 System Setup
3-7
Quick Power On Self Test
This setting determines whether the quick self test is performed when the power is turned on. The available
settings are [Disabled] or [Enabled]. The factory default setting is [Enabled] and is recommended for most
users.
First/ Second/ Third Boot Device
The selections for the search drive sequence of the operating system. The available settings are [Floppy],
[HDD-0], [SCSI], [CDROM], [HDD-1], [HDD-2], [HDD-3], [USB-FDD], [USB-ZIP], [USB-CDROM],
[USB-HDD], [LAN], and [Disabled]. Factory settings are: First: [Floppy], Second: [HDD-0], Third:
[CDROM].
Boot Other Device
Designates if a device other than the device designated in the First/Second/Third Boot Device setting will be
used for startup. The available settings are [Disabled] or [Enabled]. The factory default setting is [Disabled].
Boot Up Floppy Seek
The setting checks whether the floppy disk drive is installed during the system boot-up process.
The available settings are [Disabled] or [Enabled]. The factory default setting is [Enabled] and is recom-
mended for most users.
Boot Up NumLock Status
This setting specifies the NumLock key status upon the startup. The available settings are [On] and [Off]. The
factory default setting is [On] and is recommended for most users.
Gate A20 Option
Designates the access speed used when accessing 1MB or more of memory. Select [Fast] (Enables fast mem-
ory access - allows chipset to handle Gate A20) or [Normal] (Standard method - Windows compatible PC uses
the keyboard controller for access). The factory setting is [Fast].
Typematic Rate Setting
The setting specifies the keyboard speed used when repeating characters. The available settings are [Enabled]
and [Disabled]. The factory default setting is [Disabled] and is recommended for most users.
Typematic Rate (Chars/Sec)
This setting specifies the actual typematic rate (repeated character input per second) when the [Typematic
Rate Setting] option is set to [Enabled]. The settings are used to determine how many repeats are performed in
one second. The factory default setting is [6] and is recommended for most users.