User manual

Chapter 3 System Setup
3-5
3.2.2 IDE HDD Auto-Detection
Selecting either [IDE Primary (Secondary) Master] or [IDE Primary (Secondary) Slave] will call up the fol-
lowing menu. The following example uses the [IDE Primary Master] setting.
IDE HDD Auto-Detection
This setting detects the hard disk connected to the IDE interface.
IDE Primary (Secondary) Master (Slave)
This setting designates the IDE type Hard Disk’s parameter setting method. The available settings are [None],
[Auto], or [Manual]. The factory default setting is [Auto] and is recommended for most users.
Access Mode
This setting designates the IDE type Hard Disk’s access mode. The available settings are [CHS], [LBA],
[Large], or [Auto]. The factory default setting is [Auto] and is recommended for most users.
Capacity/Cylinder/Head/Precomp/Landing Zone/Sector
These settings designate individual IDE-type Hard Disk parameter settings. When the [IDE Primary (Second-
ary) Master (Slave)] setting is set to [Manual], the Access Mode must be [CHS]. When the [IDE Primary
(Secondary) Master (Slave)] setting is set to [Auto], these values are automatically detected. [Capacity] is set
automatically.
Phoenix AwardBIOS CMOS Setup Utility
IDE Primary Master
IDE HDD Auto-Detection [Press Enter]
IDE Primary Master [Auto]
Access Mode [Auto]
Capacity
Cylinder
Head
Precomp
Landing Zone
Sector
Item Help
Menu Level 44
To auto-detect the HDD’s size,
head... on this channel
↑↓→←: Move Enter: Select +/-/PU/PD: Value F10: Save ESC: Exit F1: General Help
F5: Previous Values F6: Fail-Safe Defaults F7: Optimized Defaults