User manual

Chapter 2 Hardware Installation

2-13

Create a Panel Cut

Create a panel cut for the PS-A, like that pictured here. Two additional items, the installation gasket and the

installation fasteners are required when installing the PS-A.

PS-A Viewing Angle

• Be sure that the panel’s viewing angle is tilted no more than 30 degrees from parallel to the operator (i.e.

operator is directly in front).

• Avoid placing the PS-A next to other devices that might cause overheating.

• Avoid using the PS-A where the ambient temperature will be higher than the allowed specification.

• Keep the PS-A away from arc-generating devices such as magnetic switches and non-fuse breakers.

• Avoid using the PS-A in environments where corrosive gases are present.

SEE

1.5.3 Panel Cut Dimensions (page1-13)

• To obtain the maximum degree of moisture resistance, be sure to install the PS-A on a smooth,

flat surface.

• The panel itself can be from 1.6 mm [0.06 in] to 10.0 mm [0.39 in] thick

• Strengthening may be required for the panel. Be sure to consider the weight of

the PS-A when designing the panel.

Panel

Panel Cut

1.6 mm [0.06 in] - 10.0mm [0.39 in]

Must be 30 degrees or less