User manual

Compact Panel Computer PS-3700A (Eden

ESP6000-667MHz Model) User Manual

2-12

2.2.2 Installation Procedures

Follow the steps given below when installing the PS-A.

Attaching the Installation Gasket

Even if the your PS-A’s Installation Gasket is not needed to prevent water from entering the unit, the gasket

also acts as a vibration absorber and should always be attached. To install it, place the PS-A face down on a

soft surface and attach the gasket to the rear side of the display face, in the bezel’s groove (see picture below).

• Before mounting the PS-A into a cabinet or panel, check that the installation gas-

ket is attached to the unit.

• A gasket which has been used for a long period of time may be scratched or dirty,

and may have lost much of its water resistance. Be sure to change the gasket at

least once a year, or when scratches or dirt become visible.

• The corresponding gasket is CA3-WPG15-01.

• Since the gasket is flexible but not elastic, be careful not to stretch it unnecessar-

ily, as doing so could tear the gasket.

• Be sure, when pushing the gasket into the installation groove and around the cor-

ners of the PS-A, that the gasket’s seam is not placed in a corner. Placing the

seam here could eventually cause the gasket to tear

• Be sure to place the gasket’s flat, non-grooved side facing down.

• If the installation gasket is not properly inserted into the groove, the gasket’s

moisture resistance may not be equivalent to IP65f.

• When the installation gasket is properly inserted, approximately 2.0 mm of it will

extend outside the groove. Before installing a PS-A into a panel, be sure to con-

firm that the gasket is correctly in place.

asket sea

PS-A Rear Face

Gasket

Installation

Groove