User manual

Chapter 2 Hardware Installation
2-7
2.1.6 USB Cable Clamp Installation
This holder prevents the USB cable from becoming disconnected due to vibration, etc.
(1) Place the PS-A unit face-down on a flat surface as shown below. Your PS-A unit has two USB connec-
tors.
[Attachment]
As shown below, insert the USB Cable Clamp’s band through the Bridge. Pass the USB cables through the
Cable Clamp’s band and securely tighten the clamp band around the cables.
[Removal]
To remove the clamp from the USB cables, push down on the clamp strap’s clip to release it while pulling up
on the clamp.
• When using only one of the USB ports, be sure to use the lower USB connector. This allows you
to securely clamp the USB cable in the cable clamp.
• Be sure the clamp is securely holding the USB cable’s plug and collar.
• Be sure the clamp is positioned as shown below, with the clamp pointing upwards - not to the
side. This is to keep the clamp from interfering with nearby connectors and their cables.
Upper USB Connecto
r
Lower USB Connecto
r
Clamp
Bridge
USB Cables
Cable Collars
Clamp
Strap Clip