User manual

Compact Panel Computer PS-3700A (Eden

ESP6000-667MHz Model) User Manual

2-2

2.1 Installtion

A wide variety of optional units, Main Memory, CF cards, PCMCIA (PC cards) manufactured by Digital

Electronics Corporation and commercial expansion boards (PCI bus compatible board *1), PCMCIA (PC

Cards) can be used with the PS-A. Unscrew the five (5) cover attachment screws, and remove the cover.

Install the desired products as shown in the "2.1.2 PS-A Internal View" drawing.

For the detailed optional unit installation procedures, refer to that unit’s "Installation Guide".

2.1.1 Removing the PS-A Unit's Cover

Lay the PS-A unit on its side and remove the five (5) cover attachment screws. Slide the rear cover up to

remove it in the direction shown. (When reattaching the screws, use a torque of 0.5 to 0.6N•m.)

Be sure to disconnect the power cord from the power supply and confirm that power is not

supplied to the PS-A unit before installing any optional units, Main Memory, CF cards, or

expansion boards. Failure to do so can result in an electric shock.

• Use a screwdriver to loosen and tighten the screws. Be sure not to tighten the

screws too tightly. Excessive force can damage the equipment.

• When removing or replacing screws, be careful that they do not fall inside the PS-

A unit's chassis.

• When installing the PS-A unit, or when attaching an optional item to the PS-A

unit, do not hold the PS-A unit by its rear-face fan cover while performing the

work. Doing so may damage the fan cover or cause the cover to fall off.