User manual

Compact Panel Computer PS-3700A (Eden
TM
ESP6000-667MHz Model) User Manual
1-8
 Switches
The following switch settings corresponding to each Serial Interface need to be signified. To set the switches,
remove the PS-A’s Rear Cover and locate the following switches, next to the PS-A’s circuit board. For infor-
mation about attaching/removing the Rear Cover,
The switches are located as follows;
Table (1) DIPSW1
("When using USB" are the DIPSW1 factory settings.)
SEE
2.1.1 Removing the PS-A Unit's Cover (page2-2)
Switch
Location
Switch Name Description
A DIPSW1
8-point dip switch. Changes the Touch Panel communication method. (Serial
<---> USB) For the details about DIPSW1, see Table (1).
(If “Serial” is selected, COM4 cannot be used.) Factory setting is same as set-
tings of “When using USB” described in Table (1).
B DIPSW2
10-point dip switch. Designates the communication method settings. For the
details about DIPSW2, see Table (2). Factory settings are all OFF. (RS-232C)
DIPSW1
No.
Description ON OFF
When
using
USB
When
using
COM4
1 Used by the system Reserved Reserved OFF OFF
2
Changes Touch Panel's communication
method
COM4 USB OFF ON
3
Switches the COM4 Touch Panel Receive
Data Communication ON or OFF
Available NOT Available OFF ON
4
Switches the COM4 Touch Panel Send Data
Communication ON or OFF
Available NOT Available OFF ON
5
Switches the External Device's
usage of
COM4 ON or OFF
Available NOT Available OFF ON
6
Switches the USB Reference Voltage ON or
OFF
Available NOT Available ON OFF
7
Switches the USB Touch Panel Positive (+)
Data Communication ON or OFF
Available NOT Available ON OFF
8
Switches the USB Touch Panel Negative (-)
Data Communication ON or OFF
Available NOT Available ON OFF
Rear
PCI
A
B
COM1
COM3
BAT