Installation guide

E-6

4 Hardware Setup

All the following explanation screens use the PS-A unit's factory settings (default

settings).

• Normally, the factory default settings should be used.

• Certain BIOS screen items may differ from those shown here due

to new versions or the PS-A unit you are using.

1) Connect a keyboard to the PS-A unit.

2) Turn the PS-A unit’s power ON.

3) When the start-up screen appears, press your PC’s [DEL] key.

The Setup utility will start. Select [Standard CMOS Features], then, [IDE Pri-

mary Master] or [IDE Primary Slave] depending on the settings of the jumper

plug to Master/Slave. The following screen will appear. (When selecting [IDE

Primary Master].)

4) Confirm whether "AUTO" is selected for IDE Primary Master/IDE Primary

Slave. Also, confirm whether "AUTO" is selected for [Access Mode]. If AUTO

is not selected, change these settings to AUTO. If AUTO is selected in both,

disk parameters will be automatically read when the PS-A is turned ON. The

factory setting is AUTO and recommended for most users.

5) After all changes are made, press the [ESC] key and select [Save & Exit Setup]

to save the settings.