Installation guide

E-4

Since the HDD unit is a precision instrument that has a low resistance to

shocks, be sure it is neither hit by nor pressed strongly against another

object when installing it.

Rear Cover

1)Place the PS-A unit face down and

unscrew five (5) attachment srews.

(See diagram)

2)Lift the Rear Cover off of the PS-

A unit.

3)Insert the PSA-HD20 cable

connector completely into the IDE

I/F.

4)Attach the PSA-HD20 using four

(4) attachment screws. (See

diagram) The torque should be 0.5

to 0.6 N•m.

5) Replace the PS-A unit's Rear Cover

and reattach five (5) attachment

screws. The torque should be 0.5 to

0.6 N•m.

Installation

Be sure to use the following installation procedures to insure that the PSA-HD20 is

correctly installed. Installation location will differ depending on the type of PS-A unit

you are using.

WARNINGS

Shock Danger! Be sure to unplug the PS-A unit from its power

supply prior to installing the PSA-HD20.

WARNING

IDE I/F



When using PS-3700A(Pentium

4 - 1.7GHz Model)/PS-3700A(Eden

ESP6000 - 667MHz Model)

The following procedure uses a PS-3700A(Pentium

4 - 1.7GHz Model) unit as an

example.