Installation guide

E-15

• To enhance the PS-A's maintainability, operability and ventilation,

allow at least 100 mm clearance between the PS-A and other objects.

(The clearance must be large enough to allow you to install or

uninstall option units and to attach connectors.)

• Standard installation for the PS-A unit is in a vertical panel. If the PS-

A unit is to be installed in a slanted panel, the panel should not incline

more than 30° from the vertical.

• If the PS-A panel is to be installed in a slanted panel that inclines

more than 30°, use forced-air cooling to ensure the ambient operation

temperature does not exceed 50° C.

• Horizontal installation (that is, rotating the panel so that one of its

sides is the base) is not supported.



 Installation Requirements

(unit: mm[in.])

[1.97]



 Attaching the PS-A to a VESA Arm or to the Wall

To attach the unit to an Arm or to a wall, use the attachment screws to attach a

commercial-type arm or wall mount adaptor to the PS-A's rear face. (Screw hole to

screw hole width: VESA 75mm)

Please refer to each device's installation guide for installation instructions.

The VESA Arm attachment screw hole dimensions are as follows;

(unit: mm[in.])

Rear Face

Insert and tighten the four (4) M4 screws. (6mm or shorter.) The torque required for

these screws is only 0.7 to 0.8 N.m.

75[2.95]

[1.97]