Specifications

PL-6930 / PL-7930 Series User Manual
4-2
4.1 Installing the PL unit
This section describes the procedures and precautions for installing the PL unit.
4.1.1 Installation Procedures
Follow the steps given below when installing the PL.
 Check the Installation Gasket’s Seating
It is strongly recommended that you use the installation gasket, since it absorbs vibration in addition to
repelling water.
For the procedure for attaching the installation gasket, refer to the following.
 Creating a Panel Cut
Create the correct sized opening required to install the PL, using the installation dimensions given.
The installation gasket and the installation fasteners are required when installing the PL.
SEE
8.4 Replacing the Installation Gasket (page8-5)
• Before installing the PL into a cabinet or panel, check that the installation gasket is
securely attached to the unit.
• A gasket which has been used for a long period of time may have scratches or dirt
on it, and could have lost much of its dust and drip resistance. Be sure to change
the gasket periodically as the scratches or dirt on the gasket becomes visible.
SEE
2.4.7 Panel Cut Dimensions (page2-24)
• Check that the installation panel or cabinet’s surface is flat, in good condition and has no
jagged edges. Also, if desired, metal reinforcing strips can be attached to the inside of the
panel, near the Panel Cut, to increase the panel’s strength.
Panel
Panel Cut
Area