Specifications

PL-6930 / PL-7930 Series User Manual
2-14
2.3.2 RAS Interface
Specification for D-sub 25pin Male is listed below.
Use #4-40 (UNC) fixing clamps to fix the joint of the interspace.
• Correspond with the DipSW setting for using the connector.
SEE
 DipSW (page1-4)
Pin Arrangement Pin No. Signal Name Meaning
1 GND Ground
2+5V
Output Current : Lower than or equal to 100mA
(with a total of 2 pin and 15 pin)
Output Voltage : 5V±5%
3+12V
Output Current : Lower than or equal to 100mA
Output Voltage : 12V±5%
4NC-
5 RST(+) Reset Input (+)
6 DIN0(+) Data Input 0 (+)
7
DOUT2 (-)
(UPS Shutdown(-))
Data Output 2 (-) (UPS Shutdown(-))
8
DOUT2 (+)
(UPS Shutdown(+))
Data Output 2 (+)(UPS Shutdown(+))
9 DOUT0 (-) Data Output 0 (-)
10 DOUT0 (+) Data Output 0 (+)
11 RST (-) Reset Input (-)
12 DIN0 (-) Data Input 0 (-)
13 DIN1 (+) Data Input 1 (+)
14 GND Ground
15 +5V
Output Current : Lower than or equal to 100mA
(with a total of 2 pin and 15 pin)
Output Voltage : 5V±5%
16 DIN2 (+) Data Input 2 (+)
17 DIN2 (-) Data Input 2 (-)
18 DIN3 (+) Data Input 3 (+)
19 DOUT1(-) Data Output 1(-)
20 DOUT1(+) Data Output 1(+)
21 DOUT3(-) Data Output 3(-)
22 DOUT3(+) Data Output 3(+)
23 DIN3 (-) Data Input 3(-)
24 DIN1 (-) Data Input 1(-)
25 NC -
• Be sure to use only the rated voltage level when using the No. 2 [+5V] and No.
3[12V] for external power output. Failure to do so can lead to a unit malfunction or
accident.
SEE
7.1 RAS Features (page7-2)
25
14
13
1