User manual

6–9
Chapter 6 – Initializing the LT
LT Series User Manual
This screen is where you can set up the touch panel’s Touch Operation and System
Reset modes, and adjust the Display settings.
6.4.3 SET UP TOUCH PANEL


 When using a monochrome model:


 When using a color model:
TOUCH OPERATION MODE
Designates either One Point, Two Points, or No Slide.
1 Point Touch
Designates that the touch panel accepts only 1 point touch input. As
soon as touch screen contact is released, touch input is cancelled.
2 Point Touch
Designates that the touch panel accepts up to 2 points of touch
input. If 3 or more points are touched simultaneously, input is not
accepted and touch input is not cancelled. In a single switch, up to 2
points can be touched.
Designates that the touch panel accepts only 1 point touch input. If
2 or more points are touched simultaneously, input is not accepted
and touch input is not cancelled.
Input is cancelled if the touch is moved (slides) outside the current
"active" area.
No Slide