User manual

4–3LT Series User Manual
Chapter 4 – OFFLINE Mode
If the LT Editor/C-Package’s SYSTEM SETUP data is trans-
ferred to the LT, the OFFLINE mode INITIALIZE data will be
overwritten.
Interrupting the screen data transfer can lead to an LT startup error.
During screen data transfer, do NOT:
• disconnect the LT unit’s power supply
• turn off the PC
• disconnect the LT unit’s transfer cable
During data transfer, the SETUP TRANSFER, NOW TRANSFERRING – PLEASE
WAIT,
and NOW WRITING – PLEASE WAIT messages appear. When these mes-
sages disappear, the screen data transfer is completed.
When the screen data transfer is completed, if you do not need to set up the LT, the
screen designated in INITIALIZE | SCREEN SET UP | INITIAL SCREEN NO. ap-
pears, and the screen changes to operation (RUN) mode.
You can cancel data transfer at any time using your LT Editor/C-Package
software’s Transfer screen.