User manual

4–1LT Series User Manual

This chapter explains how to transfer data created with the LT Editor/C-Package

to or from the LT unit. Transfer data via the data transfer cable between the LT and

the PC.

Chapter

4 Data Transfer

1. SERIAL DATA TRANSFER

2. OFFLINE Mode Main Menu

3. INITIALIZATION

The following diagram illustrates the connection between your PC and the LT

with the data transfer cable.

Data Transfer Cable/

USB Data Transfer Cable*

To PC’s serial port/

USB port

To LT unit’s tool connector

Sending the project file to the LT requires the Data Transfer cable (GPW-

CB02), which is sold separately.

Also, the I/F conversion adapter is not included with the LT. However, if

necessary, you can purchase this adapter at a computer supply store.

• Pro-face’s serial data transfer cable (GPW-CB02) and USB

data transfer cable (GPW-CB03) are sold separately. How-

ever, the data transfer cable package does NOT include

the PC’s interface conversion adapter.

• When using the PC with the Dsub 25-pin socket (female)

interface, a connector conversion adapter is required. Use

the straight-line type of conversion adapter.

Recommended adapters:

Abel Co. AA833

Sanwa Supply Co. D09-9F25F

• When using a PC equipped with a half-pitch, 14-pin socket

interface, a conversion adapter is required.

Recommended adapter:

Loas Co. ZR01-024

4.1 Data Transfer Cable

1 Software version limitations apply.

For details, USB Data Transfer Cable Installation Guide.