User manual

Chapter 3 – Installation and Wiring
3–14 LT Series User Manual
Pin Assignments Pin No. Signal Name
1DTR
2TXD
3RXD
4DSR
5GND
6RTS
7CTS
8RTS
9


 Project Manager Setup
Select [Screen/Setup]-[System Setup] in the Project Manager. The printer output
can be executed via Tool Connector by configuring the settings on the I/O Settings
tab of the [System Setup] dialog box as shown below.
C-Package: Select the Keyboard Serial option for the Printer port setting.
LT Editor: Select the Used option for the Print from Tool Connector setting.
Depending on the connected serial printer, the Type setting and the Keyboard SIO
Baud Rate setting will differ.


 Data Transfer Cable (Dub 9-Pin) Specification
The data transfer cable (Model: GPW-CB02) uses a socket-type connector. The
cable’s pins are assigned as follows:
Use inch type set screws (#4-40 UNC).
1
5
6
9
C-Package LT Editor