User manual

3–13
Chapter 3 – Installation and Wiring
LT Series User Manual
3.3 Tool Connector
WARNING
To prevent electrical shock, unplug the LT unit’s power
cord from the main power supply prior to attaching or
detaching any LT connectors.
Side View
Tool Connector
3.3.1 Serial Printer Connection


 Overview
The LT unit outputs to a printer via the tool interface. Use the optional data trans-
fer cable to connect to the user-customized conversion cable, and connect that
cable to the serial printer's connector.
Data Transfer Cable Conversion Cable
(user-created)
Serial Printer
LT
A data transfer cable or a bar-code reader can be attached to the LT unit’s tool
connector. A serial printer can be connected with a data transfer cable and a user-
customized conversion cable. The location of the LT unit’s tool connector is
shown in the following diagram.
When the Bar Code Reader uses a separate power supply:
• Turn the Bar Code Reader ON before turning the LT ON.
• Turn the LT OFF before turning the Bar Code Reader OFF.